SC-AH100F-LV LOW-VOC Model Fully-Automatic Stencil Cleaner
Sawa Ultrasonic Stencil Washer Features:
- Cleaning with Low-VOC Solvents
- Reduction of CO2 Emissions by 10% over conventional cleaner models
- Save $$ in Running Costs
- Fast Cleaning and Drying Time
How to clean Stencils with the Sawa Ultrasonic Stencil Cleaner
Ultrasonic Head Cleaning
The Sawa Ultrasonic Stencil Cleaner has two ultrasonic cleaning head panels for cleaning both the front and back sides of the metal stencil simultaneously. Ultrasonic energy is applied directly to the stencil providing superior cleaning capability.
Simultaneous Cleaning & Drying Operation
The ultrasonic cleaning and vacuum drying system work simultaneously. It takes 5 to 10 minutes to complete the combined process of cleaning and drying resulting in reduced energy consumption.
Advantages of Sawa EcoBrid Stencil Washer
Low-Running CostsWith the Sawa EcoBrid, the cleaning agent is applied to the stencil area only, vacuumdried, and then recycled (including filtering). Therefore, only a small amount of agent is used for cleaning. Other types of systems (dipping and spray types) require large amounts of solvent or chemical and require a frequent change out of solvent.
No Deterioration of StencilThe adhesive area of the stencil is not affected by usage of cleaning agent with Sawa EcoBrid. Delamination will not occur no matter how often the stencil is cleaned. Stencil repair cost is drastically reduced.
Fast Tact TimeThe ultrasonic cleaning and vacuum drying system work simultaneously to complete within five to ten minutes.
Powerful Cleaning Capability
Two ultrasonic cleaning head panels clean both the front and back sides of the metal stencil simultaneously. Ultrasonic energy is applied directly to the stencil providing superior cleaning capability.
Ease of Operation
Just press the start button and the process of cleaning and drying will be completed. No operator handling is required.
Low-VOC Cleaning Agent
Low-VOC cleaning agent, VIGON SC200 can be used for Sawa EcoBrid SC-AH100F-LV. There is no flash point, low evaporation and almost no odor. A good working environment can be maintained.
Reduction of CO2 Emission
Sawa EcoBrid SC-AH100F-LV reduces energy consumption due to the shortened tact time and accordingly reduces CO2 emissions.
|Outside Dimension||W 850×D 1,100×H 1,600 mm (W 33.46xD 43.31xH 62.99 inch)|
(NOT including signal tower)
Transformer W 320×D 350×H 305mm (W 12.60xD 13.78xH 12.01 inch) *1
|Weight||210kg (463lbs) Transformer 18kg (40lbs) *1|
|Power||AC120V 50/60Hz 400VA|
|Exhaust Duct||Exhaust rate more than 5.5m/sec Diameter φ98mm (3.86in)|
|Cleaning Solvent||VIGON SC200 (Manufactured by Zestron)|
|Cleaning/Drying Time||Approx. 10min./cycle*3|